ECU accessories

e-Series-H7.png
Pressure-transducer-IdroMOP-1-1.png

Pressure transducer

Sensor for sensing water pressure at the discharge of a pumping unit or as a pressure switch for an irrigation machine

Amperage: 4-20mA
Voltage: 10-30V
Range: 0-25 bar

Speed-sensor-IdroMOP-1.png

Speed sensor

Shielded inductive proximity sensor for reading
of the speed signal on sprinkler machines

Voltage: 10-36V
Range: 4mm

Vacuum-Sensor-IdroMOP-1.png

Vacuum sensor

Absolute sensor for depression detection
Inlet water to the pumping unit

Amperage: 4-20mA
Voltage: 10-30V
Range: 0-4 bar

Level-sensor-IdroMOP-1.png

Level sensor

Well water level sensor for water measurement
present up to a maximum of 10 meters of column

Amperage: 4-20mA
Voltage: 10-30V
Range: 0-10 m

Impulse-anenometer-IdroMOP-1.png

Pulse Anemometer

Tool for determining wind speed

Material: Anodized aluminum and stainless steel
Input: 0.75 m/s
Output: 275 herz
Accuracy: ±0.01m/s (0.3 to 16m/s);
±0.05m/s (>16m/s)
Range: 0 to >75 m/s

Electromagnetic flow meter

The electromagnetic flowmeter ensures extreme reliability because being free of moving mechanical parts such as gears, rotating turbines or bearings, it is not subject to wear and tear.
Instead, it relies on two electrodes to measure the magnetic field density induced by an electrically conductive fluid, such as water, flowing through a pipe.

The only limitation is that the fluid measured must have a conductivity greater than 5μS/cm, so non-conductive liquids, such as oil and petroleum-based products, cannot be measured with this instrument.

Supply voltage: 9-32 Vdc
Inner coating: PTFE and SS316L electrodes
Maximum working pressure: 16 bar

No loss of pressure
0.5% accuracy on measurement
Can measure flow in both directions
It is not affected by the temperature, pressure and density of the liquid

IdroMOP-Flowmeter-1.png

100 mm linear actuator

The actuator can be used with bracketing on the diesel feed pump to control engine speed

Excursion: 100mm
Speed: 10mm/sec
Installation: On bracket
Voltages: Available for power supplies
12Vdc/24Vdc

DUAL LTE Antenna + GPS

This antenna integrates the dual service of receiving LTE signal and geolocation

Gain: 5 db
Connector: 2 x SMA
Installation: 3M adhesive
Frequency range: 690-2700mHz LTE
1575.42 MHz GPS

LTE-Antenna-IdroMOP-1.png

LTE Antenna

Antenna with magnetic base for the
reception of 4G / 3G / 2G network signals

Gain: 5 db
Connector: SMA
Installation: Magnetic base
Frequency range: 690-2700 MHz

GPS-Antenna-IdroMOP-1.png

GPS Antenna

Geolocation antenna with magnetic base and 3m wire length

Gain: 28 db
Connector: SMA
Installation: Magnetic base
Frequency range: 1561-1575.42 MHz

Accessories
e Series

e Series banner
Plinth-IdroMOP-1.png

Plinth

Available for eM and eH series
Fully stainless steel
Side ventilation
Front or rear cable routing (DIY drilling)
Four lower anchor points

Chassis

When the application requires a fixed or movable frame

Coverage
Feet

Field

Through the top and up to 4 screws, the plinth and cabinet can be fixed in the middle of farmland

Plate-IdroMOP-1.png
Plate
Screws-IdroMOP-1.png
Screws

Wall

Brackets-IdroMOP-1-1.png
Brackets
Anchors-IdroMOP-1.png
Anchors

Servomotor Accessories

IdroMOP - Servo
Shaft to framework adapter
Valve spacer